Soda Maker Safety Considerations

sodastream-1018111018-3-l

You can have quite a bit of fun with a home soda maker, creating all different kinds of fizzy beverages to enjoy with friends and family. While these wonderful devices may seem simple, there are some very important safety features you need to take into consideration during both operation and the purchasing phase. This articles explains what you need to know so that you can purchase and use your new soda maker safely and comfortably.

CO2 Canisters

The most common type of soda maker carbonator involves a CO2 canister, which is a can of CO2 gas held under extreme pressure. Right off the bat, you’re going to want to follow the manufacturer’s recommendation on canisters to avoid purchasing one that either isn’t compatible with your soda maker or that might be at risk of breaking during use. If possible, look for a model that comes with a canister so you know exactly what to look for in your next refill.

Canister and Pressure

Also, once you have your soda maker, you want to make sure you don’t shake the canister up unnecessarily. This can cause the pressure to build up higher than normal, which could lead to issues when you try to operate the device. A safe soda maker will have the canister securely installed on the rear, ideally completely covered by the outer layer of the device, so it is also protected from getting hit. Impacts could cause the canister to explode.

Exposure to Heat

If the canister, or the device, is exposed to excessive heat, it could also cause the pressure in the canister to increase beyond the maximum capacity. When you use a machine that has an overpressurized canister, it could create issues filling the bottle such as sputtering or even breaking the device. Check the warnings and usage instructions for the soda maker to ensure that you keep it in an area that has the right temperature. Also, never purchase a soda make that puts any type of heat source near a CO2 canister.

Proper Filling Procedure

Even if your canister has the appropriate pressure, you still need to pay attention when you fill the bottle. Overfilling—such as by pumping too much CO2 into the water—can create too much pressure in the bottle, which could cause it to rupture while attached or shoot off when you try to remove it. Look for a soda maker with a visual or auditory warning about the pressure level.

Bottle Materials

If your soda maker uses a bottle made out of plastic, you first should make sure it is BPA-free plastic. BPA has been found to be harmful when exposed to liquids meant for consumption, so you should steer clear of it completely. Even if the bottle is BPA-free, it will have a lifespan of about two years because of wear and tear as well as a general risk of contamination. You don’t have to worry about either of these issues with glass bottles.

Special Concerns for Electric Models

If you have a machine that you plug into a power source, then you need to make sure that you don’t spill any water near the outlet or on any of the external components. This can occur when filling up the water reservoir, if it has one, or when attaching the actuator to the bottle. Water exposure can cause a short in the motor, which could not only break the device but result in bodily harm if you’re touching the machine at the time. Most electric models are built to insulate the electrical components from water, but it’s incredibly important to be mindful of how you fill it and how the soda maker comes into contact with water.

Closing Points

As long as you pay attention to the basic components of your soda maker, and read through the instructions for proper procedure, you can ensure your safety while using it. Also, you should only use manufacturer-recommended products with your soda maker, as nonstandard items may not fit properly and could result in unsafe conditions and other issues.